Below is my skateboard print project that was exhibited in 2017 at Augsburg University. This was accomplished by first making the imagery and patterns in Illustrator, then I used a laser printer and reversed the image during the print process. Application was a generous coating of Mod Podge on both the skateboard and over the imagery after carefully laying it into place. After 24 hours of letting the inks settle, I used a wet towel to soak and gently wipe away the printer paper. I, myself, enjoy the imperfections. If you decide to try this, TAKE YOUR TIME WIPING AWAY THE PAPER :)

This is the end result– 

Details of the board and a sticker!